Nickel Plated Half Link #65

Description

#65 nickel plated half link (offset link) for #65 roller chain. It adds one pitch to the chain so you can use an odd number of pitches and fine-tune length. The nickel plating resists rust better than plain steel links in wet or coastal areas. Sold individually.

Use it on slide gate operator drive chain when a full link leaves the chain too long or too short for the chain bolts to set tension.

Features

• Fits #65 roller chain, 1/2 in pitch
• Offset design adds one pitch
• Lets the chain end on an odd pitch count
• Nickel plated for corrosion resistance

Before You Order

• Order the same chain size as your chain. A #65 half link will not fit other chain sizes.
• #65 chain is also sold as #48 chain. Both names refer to the same 1/2 in pitch chain with a 1/8 in inner width.
• A half link is not a master link. You still need a #65 nickel plated master link to close the chain.
• Most gate chains do not need a half link. Use one only when chain bolt travel can't take up the extra length.
• Other nickel plated half link sizes: #40, #41 and #50.
• Match the finish to your chain. A nickel plated link keeps the same corrosion resistance as nickel plated chain.