AES e-Loop Commercial Wireless Loop Kit - Presence Mode

AES ITEM: EL00C-RAD-K
AES e-Loop Commercial Wireless Loop Kit - Presence Mode
AES e-Loop Commercial Wireless Loop Kit - Presence Mode
AES e-Loop Commercial Wireless Loop Kit - Presence Mode
AES e-Loop Commercial Wireless Loop Kit - Presence Mode
AES e-Loop Commercial Wireless Loop Kit - Presence Mode
AES e-Loop Commercial Wireless Loop Kit - Presence Mode
AES e-Loop Commercial Wireless Loop Kit - Presence Mode
AES e-Loop Commercial Wireless Loop Kit - Presence Mode
AES e-Loop Commercial Wireless Loop Kit - Presence Mode
AES e-Loop Commercial Wireless Loop Kit - Presence Mode
AES e-Loop Commercial Wireless Loop Kit - Presence Mode
AES e-Loop Commercial Wireless Loop Kit - Presence Mode
AES e-Loop Commercial Wireless Loop Kit - Presence Mode
AES e-Loop Commercial Wireless Loop Kit - Presence Mode

AES e-Loop Commercial Wireless Loop Kit - Presence Mode

AES ITEM: EL00C-RAD-K
Regular price $634.00
/
  • Free shipping on most items over $200
  • We have 15+ years of industry experience
  • GSA, Net 30 and purchase orders available
Shipping calculated at checkout.

Description

Description

Are you looking for a free exit option that does not require cutting into your driveway or digging a trench for a classic inductive loop or vehicle probe.  This wireless option mounts on the driveway and communicates to a transceiver up to 150' away!

The Commercial Wireless Vehicle Detection System uses magnetometer sensors to detect the presence of oncoming vehicles. These detections are transmitted to a nearby transceiver for gate activation. After the vehicle is detected, the e-loop will switch to radar mode. The sensors are installed on the surface of entry or exit passages using dynabolts, contain four replaceable Lithium batteries, and can withstand almost any vehicle.

The Radar sensors can detect vehicles that are stopped above the e-loop. The added radar utilises a two-way radio communication protocol for reliable operation. Once the magnetometer sensor detects an oncoming vehicle, the transceiver relay will be latched and confirmation will be sent back to the e-loop. If the magnetic field drops below the set threshold, the radar will check if a vehicle is present. If no vehicle is detected, an unlatch command is sent to the relay, and the transceiver will send a confirmation to the e-loop. If the confirmation is missed, multiple attempts will be made to ensure A safe operation. Radar settings can be adjusted using the ediagnostics remote. Settings that can be changed include; Dead zone, sensor distance, sensitivity, magnetic field release level, and confirmation mode.

Kit Contents:

1 x e-Loop commercial Presence mode wireless detection module.
1 x e-Trans 50 transceiver unit.
2 x Dyna bolts.

The e-Loop Commercial Wireless Loop is to be mounted in middle of driveway so vehicles pas over the top without running it over, but is rugged enough to withstand most cars/trucks up to approximately 10 Tons.  

The e-Trans 50 transceiver has a single output relay (NO/C/NC) that wires to open in the gate operator.  It is recommended the transceiver be mounted in a weatherproof plastic box.

Features

Installation in 3 simple steps
1 - Code in e-Loop.
2 - Secure e-Loop to the driveway.
3 - Calibrate e-Loop ... and you're ready. to operate in less than 15 minutes.

Compact profile - only 8.6" x 1".

Not affected by ground movement.

10600 mA battery giving up to 10 years battery life.

High security 128 bit encryption.

Range up to 50 meters.

Made of high impact plastic (10 tonne static load limit)

Specifications

Frequency 433.39 MHz
Modulation FSK
Bitrate 9.6 kbps
Bandwidth 250 kHz
Antenna Type PCB
Nominal Output Power 10 dBm
Receive Sensitivity -126.2 dBm
Security 128-Bit AES Encryption
Power 4 * 3.6 V 2700ma
Dimensions 8.6*8.6*1 inches
Weight 2.2 pounds
Environment • designed for aboveground mounting• IP68 ingress protection
Operating Temp -4°F to 176°F
Standby Power 14μA
Activation Power 50mA



 

 Literature and Resources

 

Installation in 3 simple steps 1 - Code in e-Loop. 2 - Secure e-Loop to the driveway. 3 - Calibrate e-Loop ... and you're ready. to operate in less than 15 minutes.

Compact profile - only 8.6" x 1".

Not affected by ground movement.

10600 mA battery giving up to 10 years battery life.

High security 128 bit encryption.

Range up to 50 meters.

Made of high impact plastic (10 tonne static load limit)

All in stock orders typically ship the same business days or within 1-2 business days.  Cut off for same day shipping is 2:30PM Central Time.

LEADTIME

Items with lead times typically ship in 4-7 business days.

FREE SHIPPING POLICY

Orders with free shipping may have longer lead times due to those items being shipped the most economical way.  Free shipping on most orders over $195.00 does not include gate operators, loop sealant, and any extreme length or weight items

Our return policy lasts for only 30 days. If 30 days have gone by since your purchase, unfortunately we can’t offer you a refund. Some items such as Gate Operators or custom parts may not be returnable or carry a restocking fee if returned.

Read return policies

Protec Controls accepts purchase orders please contact us.

NET 30

We also support Net 30 terms on our website for easy ordering. Please fill out the form to the right with your company information and we will get your account setup to place Net 30 orders.

GOVERNMENT & GSA

Protec Controls accepts GSA SmartPay cards along with all major credit cards. For government quotes and purchase orders please email govsales@proteccontrols.com

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.

Reviews