BEA EVOLOOP Manuals & Support

The BEA EVOLOOP is a 60 GHz radar sensor that replaces in-ground loops at automatic barrier arms. It mounts on the barrier 12 to 27 in above the road and sees up to 23 ft out.

It sets up to 3 virtual loops for presence or protection, with filters for target type and direction. Setup is done from the BEA mobile app over Bluetooth.

Identify your model

The EVOLOOP has four LEDs: one for each virtual loop and a white Bluetooth LED. Plastic and metal housing versions are available.

Key specs

Technology	60 GHz FMCW radar
Detection	Up to 3 virtual loops, presence or protection
Range	Up to 23 ft
Field of view	140° wide, 40° high
Mounting height	12 to 27 in above the road
Power	12 to 30 VDC or 12 to 24 VAC, under 3 W
Outputs	2 electronic relays plus 1 relay
Setup	BEA mobile app over Bluetooth
Housing	IP65
Operating temperature	-13 to 131 °F

Manuals and documents

Troubleshooting

Each loop LED shows that loop's status. The third LED also shows error status. The white LED blinks while Bluetooth is on.

Cannot connect with the app

Bluetooth stays on for 30 minutes after power up or the last use. Cycle power to turn it back on.
The first-time pairing code is 456789.

Missed or false detects

Check the mounting height, 12 to 27 in above the road, and the antenna angle.
Run a teach-in from the app with the lane clear.
Set the target type and direction filter to ignore cross traffic.

Arm comes down on a vehicle

Make sure a protection loop covers the area under the arm.

Common questions

No. It replaces in-ground loops with up to 3 virtual loops set in the app.

Yes. Set one loop for presence to open the arm and one for protection to keep it from closing on a vehicle.

The first-time Bluetooth pairing code is 456789. Bluetooth turns off 30 minutes after power up or last use.