Part of the EZ Parts Finder: pick a part on the diagram or use the list below.
The photos on this page show a DoorKing 1601 barrier gate operator from the main housing to the front, the control board and the motor. Use them to see where each part sits. The list below has the 1601 parts we carry with their DoorKing part numbers, including the 1601-010 circuit board, arm and arm hardware, the photo eye and plug-in loop detectors.
Identify your model
The 1601 nameplate lists the class, model, serial number, HP, volts and phase, amps and maximum gate load. The 1601 is the 1/2 HP model with arms up to 14 ft, and the 1602 is the 1 HP model with arms up to 28 ft. On the circuit board, switch 1 of SW 2 is OFF for a 1601 and ON for a 1602. Models ending in 381 or 481 have convenience open.
Operator and manuals
- 1601 installation manual (PDF)
- 1601 cut sheet (PDF)
- 1601 breakaway round arm (PDF)
Most ordered parts
- Doorking 9410-010 Single Channel Loop Detector (9410-010)
- Doorking 8080-057 Retro-Reflective Photoeye (8080-057)
- Doorking 9409-010 Dual Channel Loop Detector (9409-010)
- Doorking Replacement 1601-010 Circuit Board (1601-010)
- Doorking 9411-010 Single Channel Loop Detector w/ Relay (9411-010)
Parts list by assembly
Control Board
| Part number | Part |
|---|---|
| 1601-010 | Doorking Replacement 1601-010 Circuit Board |
Arms and Edges
| Part number | Part |
|---|---|
| 1601-567 | DKS 1601-567 14' Arm 2 pc |
| 1601-242 | DoorKing 1601-242 Arm Hardware |
| 8080-057 | Doorking 8080-057 Retro-Reflective Photoeye |
| 2600-266 | Doorking 2600-266 Operator High Voltage Kit |
| 9409-010 | Doorking 9409-010 Dual Channel Loop Detector |
| 9410-010 | Doorking 9410-010 Single Channel Loop Detector |
| 9411-010 | Doorking 9411-010 Single Channel Loop Detector w/ Relay |
Common questions
What arm length does the DoorKing 1601 take?
The 1601 takes arms up to 14 ft and raises the arm 90 degrees in 2.5 seconds. The 1 HP 1602 takes arms up to 28 ft.
What happens to a convenience open 1601 during a power failure?
Convenience open models use a DC limit sensor to hold the arm up during an AC power failure.
How do I set the board for a 1601?
Set switch 1 of SW 2 on the circuit board to OFF for a 1601. It must be ON for a 1602.