AES e-Loop Post Mount Wireless Vehicle Sensor Manuals & Support

AES EL00PM-RAD-K

The AES e-Loop Post Mount is a wireless presence sensor that mounts beside the lane on a post or wall, so the driveway is not touched. It uses a magnetometer with radar confirmation.

The kit pairs the EL00PM-RAD sensor with the ETRANS50 transceiver. It runs on 2 AA lithium batteries for up to 3 years and is IP68.

Buy the EL00PM-RAD-K

Identify your model

Mount the sensor 23.6 in above ground. Vehicles must pass within 9.8 ft of it.

Key specs

Mounting height 23.6 in
Detection range Up to 9.8 ft
Radio 433.39 MHz, 128-bit AES, up to 164 ft
Power 2 x AA lithium, up to 3 years
Rating IP68
Transceiver ETRANS50, 10 to 36 VDC, 1 A relay

Manuals and documents

Installation Manual

Spec Sheet

Troubleshooting

Sensor does not trigger

  • Code the sensor to the transceiver again.
  • Recalibrate with no vehicle near the sensor.
  • Check the sensor batteries.

Error LEDs

  • Run the test mode and compare the LEDs to the AES LED display guide.

Common questions

Where the driveway surface cannot be cut or drilled.

23.6 in above ground, within 9.8 ft of passing vehicles.

No. AES says not to use presence mode as a personal safety device.