All-O-Matic SW-325 DC PRO Swing Gate Operator Manuals & Support

All-O-Matic SW-325 DC PRO

The All-O-Matic SW-325 DC PRO is a swing gate operator for gates up to 20 ft and 2,000 lb. It has a 1/2 HP 24 VDC brushless motor, a 750:1 gearbox with internal clutch and continuous duty.

The ALL-BLDC PRO board adds an LCD with diagnostics, a 7-day timer, wireless primary and secondary pairing, a USB port and a cycle counter. An AOM-RED EYE photo eye is included.

Buy the SW-325 DC PRO (2 options)

Identify your model

The SW-325 DC PRO mounts on a pad (SPD-320/325) or post (SPT-325). Older SW-325 DC units without the PRO board use the SW-300/325/350 DC manual below.

Key specs

Max gate 2,000 lb / 20 ft
Motor 24 VDC brushless, 1/2 HP
Open time 14 to 25 seconds to 90°, adjustable
Power 115 or 230 VAC single phase; 24 VDC solar
Duty Continuous
Battery backup Two 7 Ah 12 VDC; up to 250 cycles
Gearbox 750:1 with internal clutch
Warranty 7 years residential, 5 years commercial
Operating temperature -40 to 160 °F

Manuals and documents

Installation Manual

Spec Sheet

Brochure

Troubleshooting

MODE LED

  • 1 blink every 2 seconds: motor hall sensor feedback problem. Check the motor harness.
  • 2 blinks: motor overload.
  • 3 blinks: gate jammed.

ALARM LED

  • Blinks every 30 seconds with a beep: batteries are low, bad or disconnected.
  • On for 5 minutes with the alarm: the gate hit an obstruction twice and shut down (ERD). Clear the gate path.

Gate will not move

  • MON_OPEN or MON_CLOSE on means a monitored device is not installed, misaligned or faulty.
  • STOP CMD or SAFETY LOOP on means that input is open. Check the wiring.

Common questions

Yes. The AOM-RED EYE photo eye comes with the SW-325 DC PRO.

Yes. The PRO board has wireless primary and secondary pairing.

Up to 250 cycles with the two 7 Ah batteries.