All-O-Matic SW-375 DC Swing Gate Operator Manuals & Support

All-O-Matic SW-375 DC

The All-O-Matic SW-375 DC is a heavy duty swing gate operator for gates up to 30 ft and 5,000 lb. It has a 36 VDC brushless motor, an adjustable torque limiter and continuous duty.

It runs on 115, 230 or 480 VAC single phase or 36 VDC solar, with built-in battery backup of three 14 Ah batteries for up to 300 cycles on a 2,000 lb gate.

Buy the SW-375 DC

Identify your model

The SW-375 DC has a large frame with two gearboxes and a 5/8 in bolt emergency release on the arm. It shares its manual with the SL-175 DC slide operator.

Key specs

Max gate 5,000 lb / 30 ft
Motor 36 VDC brushless
Open time 14 to 27 seconds to 90°, adjustable
Power 115, 230 or 480 VAC single phase; 36 VDC solar
Duty Continuous
Battery backup Three 14 Ah 12 VDC; up to 300 cycles on a 2,000 lb gate
Gearbox 30:1 large, 10:1 small
Breaker 20 A dedicated
Operating temperature -40 to 160 °F

Manuals and documents

Installation Manual

Parts List

Brochure

Troubleshooting

MODE LED

  • 1 blink every 2 seconds: motor hall sensor feedback problem. Check the motor harness.
  • 2 blinks: motor overload.
  • 3 blinks: gate jammed.

ALARM LED

  • Blinks every 30 seconds with a beep: batteries are low, bad or disconnected.
  • On for 5 minutes with the alarm: the gate hit an obstruction twice and shut down (ERD). Clear the gate path.

Gate will not move

  • MON_OPEN or MON_CLOSE on means a monitored device is not installed, misaligned or faulty.
  • STOP CMD or SAFETY LOOP on means that input is open. Check the wiring.

Common questions

Up to 5,000 lb and 30 ft.

Up to 300 cycles on a 2,000 lb gate with the three 14 Ah batteries.

A dedicated 20 A breaker.