ASO Edges SENTIR 25.30 and 25.45 Safety Edges Manuals & Support

ASO Edges ASO 25.30 TT / ASO 25.45 TT

ASO SENTIR 25 edges are contact safety edges for automatic gates. The T-foot slides into an aluminum rail on the gate, and the edge switches when it is pressed.

A resistor at the end lets the operator monitor the edge for breaks and shorts. Up to 5 edges can be wired in series.

Buy the ASO 25.30 TT / ASO 25.45 TT (9 options)

Identify your model

25.30 TT: small profile, 25 x 30 mm. 25.45 TT: large profile, 25 x 45 mm. Lengths 4, 5 and 6 ft. Resistor 10K, 8K or 8.2K (the 8.2K edge is listed for LiftMaster).

Key specs

Profiles 25 x 30 mm or 25 x 45 mm
Lengths 4, 5 and 6 ft
Resistor 8K, 8.2K or 10K
Rating IP67
Standards UL 325, EN ISO 13856-2
Series Up to 5 edges

Manuals and documents

Installation Manual

Troubleshooting

Operator shows an edge fault

  • Check the resistor value matches the operator input.
  • Check the wire and plug for cuts.
  • Measure the edge with a meter: it should read the resistor value at rest.

Edge does not stop the gate

  • Check the edge input is set to monitored edge on the board.
  • Check the edge is in its rail and not crushed.

Common questions

Match the monitored edge input on your operator, such as 8.2K for LiftMaster or 10K.

Yes, up to 5.

The T-foot slides into an ASO aluminum mounting rail.