Diablo DSP-11 Micro Plug-In Vehicle Detector Manuals & Support

Diablo DSP-11-LV / DSP-11-117

The Diablo Controls DSP-11 is a micro single channel plug-in loop detector with one relay output and a standard 11-pin connector. It tunes itself to the loop.

It is fail-safe, so the output goes to detect if the loop fails. The DSP-11-LV runs on 10 to 30 VDC or 10 to 28 VAC.

Buy the DSP-11-LV / DSP-11-117 (2 options)

Identify your model

The DSP-11 is 1.4 x 1.4 x 2.75 in. Pins 1 and 2: power. Pin 5: relay common, 6: NO, 10: NC. Pins 7 and 8: loop. DSP-11-117 is the 115 VAC version.

Key specs

Power (LV) 10 to 30 VDC or 10 to 28 VAC
Relay NO and NC, 1 A
Connector 11-pin
Fail mode Fail-safe
Loop inductance 20 to 2,000 µH
Operating temperature -35 to 165 °F

Manuals and documents

Installation Manual

Spec Sheet

Other documents

Troubleshooting

Gate does not open or reopen

  • Check the detect LED when a vehicle is on the loop.
  • Raise the sensitivity one step at a time.

Detector stays in detect

  • Check the loop and lead-in for a break or short to ground.
  • Reset the detector so it retunes.

Random detects

  • Set nearby detectors to different frequencies.
  • Check that the lead-in is twisted and the saw cut is sealed.

Common questions

A blink once a second is normal. A slow blink means an open loop and a fast blink a shorted loop.

No. It adjusts itself to the loop and lead-in.

Use the DSP-11-LV on low voltage and the DSP-11-117 on 115 VAC.