Diablo DSP-7 Micro Vehicle Detector Manuals & Support

Diablo DSP-7

The Diablo Controls DSP-7 is a micro single channel loop detector with one relay output and a 7-pin terminal block. It runs on 10 to 30 VDC or 10 to 28 VAC.

It has no switches to set. It tunes itself to the loop and is fail-safe, so it can be used on a safety loop.

Buy the DSP-7

Identify your model

The DSP-7 is 1.52 x 2.9 x 1.56 in and draws about 35 mA with no vehicle. Wiring is the same as the DSP-7LP.

Key specs

Power 10 to 30 VDC or 10 to 28 VAC
Current draw About 35 mA, no vehicle
Relay NO and NC, 1 A
Fail mode Fail-safe
Loop inductance 20 to 2,000 µH
Operating temperature -35 to 165 °F

Manuals and documents

Installation Manual

Spec Sheet

Troubleshooting

Gate does not open or reopen

  • Check the detect LED when a vehicle is on the loop.
  • Raise the sensitivity one step at a time.

Detector stays in detect

  • Check the loop and lead-in for a break or short to ground.
  • Reset the detector so it retunes.

Random detects

  • Set nearby detectors to different frequencies.
  • Check that the lead-in is twisted and the saw cut is sealed.

Common questions

A blink once a second is normal. A slow blink means an open loop and a fast blink a shorted loop.

Yes. The DSP-7LP is the low power version for solar gates.

No. It adjusts itself to the loop and lead-in.