DoorKing Control Stations Manuals & Support

DoorKing control stations give manual open, close and stop control of a gate, plus exit buttons and key switches. Most mount in a single gang box with a stainless faceplate.

Three-button stations must be wired to match the operator board. The 1200-006 and 1200-007 use a normally open stop circuit.

Identify your model

The 1200-006 is for indoor or outdoor use and the 1200-007 is indoor only. The 1200-016 is a surface mount gate controller and the 1211-081 is a mullion exit button.

The 1200-006 and 1200-007 do not work with boards ending in -012 or -018, except the 4502 boards in the 6050, 6100 and 6300.

Key specs

Three-button	1200-006 (indoor/outdoor), 1200-007 (indoor)
Gate controller	1200-016, surface mount
Exit button	1211-081, mullion mount
Key switch	Mortise cylinder, can be re-keyed
Wire	18 AWG

Manuals and documents

Wiring Diagram

3-Button Control Station Wiring (Open, Close, Stop)
1200-060-H-12-20 · 1 page View PDF: 3-Button Control Station Wiring (Open, Close, Stop) (opens in a new tab)

Spec Sheet

Gate Operator Control Stations Spec Sheet
Rev. 7-26 · 2 pages View PDF: Gate Operator Control Stations Spec Sheet (opens in a new tab)

Troubleshooting

Stop button does not work

Boards ending in -012 or -018 need a four-wire normally closed stop circuit. The 1200-006 and 1200-007 will not work on them, except on 4502 boards.

Mounting

Mount control stations at least 6 ft from the gate, or where the user cannot touch the gate while using them.

Common questions

It works with boards that use a normally open stop circuit, and with any 4502 board. It does not work with other boards ending in -012 or -018.

At least 6 ft, or where the user cannot touch the gate while using it.

Yes. It uses a mortise cylinder that can be re-keyed.