EDI LMA-1400 DEFLECTOMETER Loop Detector Manuals & Support
This model is discontinued. Manuals and replacement parts for existing units are listed below.
Identify your model
-M: relay, 10-pin male Molex. -MS: solid state, fail-secure. -F and -FS: female Molex. -B and -BS: terminal block.
Key specs
| Power | 12 to 24 VDC or 24 VAC |
|---|---|
| Outputs | 2 relay or solid state |
| Display | DEFLECTOMETER |
| Temperature | -30 to 165 F |
Manuals and documents
Installation Manual
-
LMA-1400 Operating Instructions
View PDF: LMA-1400 Operating Instructions (opens in a new tab) -
Loop Installation Guide
View PDF: Loop Installation Guide (opens in a new tab) -
General Loop Installation Guidelines
View PDF: General Loop Installation Guidelines (opens in a new tab)
Spec Sheet
-
LMA-1400 Cut Sheet
View PDF: LMA-1400 Cut Sheet (opens in a new tab)
Other documents
-
Loop Sizes and Loop Characteristics Chart
View PDF: Loop Sizes and Loop Characteristics Chart (opens in a new tab)
Troubleshooting
Common questions
EDI names no direct replacement. For female Molex ports use the LMA-1800.
Match the connector and output to the operator.
How much the loop changes, to help set sensitivity.