HySecurity SlideSmart CNX Gate Operator Manuals & Support

HySecurity CNX 15

This model is discontinued. The current replacement is the HySecurity SLS535 - SlideSmart 535 Slide Gate Operator. Manuals and replacement parts for existing units are listed below.

The HySecurity SlideSmart CNX 15 is a connected slide gate operator for gates up to 50 ft and 1,500 lb. It has a 24 V brushless DC motor with a direct drive gear train and continuous duty.

It has BlueBUS, an OXI receiver socket, Bluetooth setup with the SmartCNX app and battery backup for up to 4,000 ft of gate travel. HySecurity has replaced it with the SlideSmart 535.

Buy the CNX 15

Identify your model

The SlideSmart CNX uses the SmartCNX controller. Units can take the SmartBLDC power module retrofit kit. The replacement is the SlideSmart 535.

Key specs

Max gate 1,500 lb / 50 ft
Pull force 300 lb
Speed 0.75, 1 or 1.25 ft per second
Motor 24 V brushless DC, 1/2 HP equivalent
Duty Continuous
Battery backup Two 8 Ah: up to 4,000 ft; two 35 Ah: up to 16,000 ft
Connectivity Bluetooth, BlueBUS, OXI, HyNet
Operating temperature -13 to 158 °F

Manuals and documents

Installation Manual

Parts List

Spec Sheet

Troubleshooting

Use the SmartCNX app or the controller display to read the event log.

How to clear codes

  • ALERT: low priority. Give a new Open or Close command.
  • FAULT: press Stop or Reset.
  • ERROR: serious. Push Reset or cycle power, and call for service if it returns.

Common codes

  • ALERT 1, Forced Open: the gate was pushed off its limit. Check locks, alignment and the limit switch.
  • ALERT 8, Loop Shorted: megger the named loop to ground and check the lead-in.
  • ERROR 1, Direction Error: the opposite limit tripped. Check the limit switches and that their cables are in the right connectors.

Controller LED

  • The heartbeat LED on the controller flashes steadily during normal operation. If it is off, AC power is lost.

Common questions

No. HySecurity has replaced it with the SlideSmart 535. Manuals and parts for existing units are on this page.

UL 325 requires monitored external entrapment protection. Connect a monitored photo eye or edge and run the setup again.

Yes. Use the SmartCNX installer app over Bluetooth.