Nice Apollo 3501 Vanguard Swing Gate Operator Manuals & Support

Nice Apollo 3501

The Nice Apollo 3501 Vanguard is a 12 VDC post mount articulating arm swing gate operator for gates up to 20 ft and 1,000 lb. Add the 35-2 for a dual gate.

It uses the 1050 control board with the OXI/A receiver and ABF/A antenna, opens in 12 to 20 seconds, is solar compatible and meets UL 325 6th Edition.

Buy the 3501

Identify your model

The kit includes the CBOX1050 and the 35-1 chassis with the ABOX35 arm. The 35-2 secondary comes with a 42 ft harness. Units built before 2024 may use the older motor; see the motor replacement instructions.

Key specs

Max gate 1,000 lb / 20 ft per leaf
Open time 12 to 20 seconds
Input 12 to 30 VDC
Operating voltage 12 VDC
Standby current 10 mA
Control board 1050 with OXI/A receiver
Mount Post, 4 x 4 heavy wall recommended
Operating temperature -40 to 150 °F

Manuals and documents

Installation Manual

Spec Sheet

Service Bulletin

Troubleshooting

Operator will not power on

  • Check that power to the board is on and look for loose or broken wires.
  • Check the fuses. The 1050 runs on 10 to 32 VDC only; never connect AC power to the board.

Gate opens a short distance, then stops and reverses

  • Check the UL/Edge input and the monitored sensors.
  • Adjust the force settings.

Gate opens but will not close

  • Any lit input LED holds the gate open. Check keying devices, safety devices and loop detectors.

Hard shutdown

  • Two back-to-back obstructions make the LED blink and the buzzer sound for 5 minutes. Clear the gate path and press RESET.

No battery backup operation

  • Check whether backup is set to open automatically or waits for an input. Check battery voltage and replace weak batteries.

Common questions

Add the 35-2 chassis kit with its 42 ft harness.

For UL 325 7th Edition, at least one monitored external entrapment sensor for swing operators and two for slide operators. Nice BlueBUS photo eyes connect with two wires.

Nice Era One and Inti rolling-code remotes through the OXI receiver. The 1050 board supports up to 1,000 remotes.