Seco-Larm E-931-S45RRQ Reflective Photo Beam Manuals & Support

Seco-Larm E-931-S45RRQ

The Seco-Larm E-931-S45RRQ is a retro-reflective photo beam with a 45 ft range. It runs on 12 to 250 VAC or VDC and has adjustable range and response time.

It has a SPDT relay rated 3 A, an IP66 housing, a 6 ft pre-wired cord and a 3 in round reflector with hood. It does not have a monitored output.

Buy the E-931-S45RRQ (2 options)

Identify your model

The sensor has a yellow alignment LED and a red trigger LED. Optional single-gang and wall brackets are available. The E-931-S35RRQ is the 35 ft version, on 12 to 240 VDC or 24 to 240 VAC.

Key specs

Range 0.5 to 45 ft
Operating voltage 12 to 250 VAC or VDC
Current draw 70 mA at 12 VDC
Output SPDT relay, 3 A at 115 VAC or 30 VDC
Response time 5 to 100 ms, adjustable
IP rating IP66
Operating temperature -4 to 131 °F

Manuals and documents

Installation Manual

Spec Sheet

Troubleshooting

Sensor does not detect

  • Change the sensor angle or readjust the sensitivity.
  • Shiny objects can reflect the beam back. Use a polarized sensor where shiny vehicles pass.

Alignment LED will not show a good signal

  • Clean the sensor lens and reflector with a damp cloth.
  • Re-aim the sensor and reflector so the beam lands in the center of the reflector.

LED shows a trip but the gate or panel does not respond

  • Check the wiring between the sensor relay and the operator or panel input.
  • On monitored inputs, use the output type the operator expects: N.C. or 10k ohm.

Common questions

No. For monitored gate inputs use the E-936-S45RRGQ or E-931-S50RRGQ.

12 to 250 VAC or VDC.

Yes. A 3 in round reflector with hood is included.