Seco-Larm E-931-S50RR Reflective Photo Beams Manuals & Support

Seco-Larm E-931-S50RRGQ / E-931-S50RRLQ

The Seco-Larm E-931-S50RRGQ is a reflective photo beam with a 50 ft range and a monitored output (N.C. or 10k ohm) for gate operators. It runs on 12 to 30 VAC or VDC.

It has a dual-color alignment LED, anti-condensation housing, tamper switch and a 3-1/4 in reflector with hood. The E-931-S50RRLQ is the version with a large reflector that runs on 12 to 250 VAC or VDC.

Buy the E-931-S50RRGQ / E-931-S50RRLQ (2 options)

Identify your model

The sensor LED shows solid green when aligned, alternating when the signal is weak and solid red when the beam is blocked.

Key specs

Range Up to 50 ft
Operating voltage GQ: 12 to 30 VAC or VDC; LQ: 12 to 250 VAC or VDC
Current draw 55 mA standby, 40 mA active at 12 VDC
Output SPDT relay, 500 mA at 30 VAC/VDC
Monitoring GQ: N.C. or 10k ohm
Tamper N.C., 500 mA at 30 VAC/VDC
IP rating IP55
Operating temperature -13 to 140 °F

Manuals and documents

Installation Manual

Spec Sheet

Troubleshooting

Sensor does not detect

  • Change the sensor angle or readjust the sensitivity.
  • Shiny objects can reflect the beam back. Use a polarized sensor where shiny vehicles pass.

Alignment LED will not show a good signal

  • Clean the sensor lens and reflector with a damp cloth.
  • Re-aim the sensor and reflector so the beam lands in the center of the reflector.

LED shows a trip but the gate or panel does not respond

  • Check the wiring between the sensor relay and the operator or panel input.
  • On monitored inputs, use the output type the operator expects: N.C. or 10k ohm.

Common questions

Solid green is good alignment, alternating is a weak signal, and solid red means the beam is blocked.

The E-931-S50RRGQ has N.C. and 10k ohm monitored outputs.

The E-931-S50RRLQ runs on 12 to 250 VAC or VDC. The GQ is 12 to 30 V only.