Seco-Larm E-936-S45RRGQ Monitored Reflective Photo Beam Manuals & Support

Seco-Larm E-936-S45RRGQ

The Seco-Larm E-936-S45RRGQ is a retro-reflective photo beam with a monitored output for UL 325 gate operators. It senses up to 45 ft and runs on 12 to 30 VAC or VDC.

It has a SPDT relay, N.C. and 10k ohm monitoring options, an IP66 housing and a 6-1/2 ft pre-wired cord. It replaces the E-936-S35RRGQ.

Buy the E-936-S45RRGQ (2 options)

Identify your model

The sensor has a yellow alignment LED and a red trigger LED. The reflector comes with its own bracket. The older E-936-S35RRGQ had a 35 ft range.

Key specs

Range 0.5 to 45 ft
Type Retro-reflective
Operating voltage 12 to 30 VAC or VDC
Current draw 70 mA at 12 VDC
Output SPDT relay, 2 A at 30 VAC/VDC
Monitoring N.C. or 10k ohm
Response time 10 ms
IP rating IP66
Operating temperature -4 to 131 °F

Manuals and documents

Installation Manual

Spec Sheet

Troubleshooting

Sensor does not detect

  • Change the sensor angle or readjust the sensitivity.
  • Shiny objects can reflect the beam back. Use a polarized sensor where shiny vehicles pass.

Alignment LED will not show a good signal

  • Clean the sensor lens and reflector with a damp cloth.
  • Re-aim the sensor and reflector so the beam lands in the center of the reflector.

LED shows a trip but the gate or panel does not respond

  • Check the wiring between the sensor relay and the operator or panel input.
  • On monitored inputs, use the output type the operator expects: N.C. or 10k ohm.

Common questions

Yes. Use the N.C. or 10k ohm output the operator calls for.

The E-936-S45RRGQ, with 45 ft range.

Yes. A reflector and brackets for both parts are included.