Seco-Larm E-964 Multi-Frequency Photobeam Detectors Manuals & Support

Seco-Larm E-964-Q330Q / Q660Q / D390Q / S50TB

The Seco-Larm E-964 series are outdoor photobeam detectors for perimeter protection. The quad models need all four beams broken to trip, and the twin model needs both, which cuts false alarms from animals and leaves.

Four selectable frequencies stop crosstalk between nearby units. The Q330Q and Q660Q have a heater and a weather output. The E-964-S50TB is a single-beam 50 ft model.

Buy the E-964-Q330Q / Q660Q / D390Q / S50TB (2 options)

Identify your model

E-964-Q330Q: quad, 330 ft outdoors. E-964-Q660Q: quad, 660 ft outdoors. E-964-D390Q: twin, 390 ft outdoors. E-964-S50TB: single beam, 50 ft. The number is the outdoor range.

Key specs

Range outdoors Q330Q: 330 ft; Q660Q: 660 ft; D390Q: 390 ft; S50TB: 50 ft
Beams Quad, twin or single
Operating voltage Q models 12 to 24 VAC/VDC; D390Q 10 to 30 VAC/VDC
Current draw Q660Q: 125 mA, 290 mA with heater; D390Q: 88 mA
Alarm output Form C relay, 1 A
Tamper N.C.
Alignment Laser and LED strength meter
IP rating IP55
Operating temperature -13 to 131 °F

Manuals and documents

Installation Manual

Spec Sheet

Troubleshooting

Detector will not align

  • Use the laser to aim each end, then fine tune with the strength LEDs.
  • Check that both ends are on the same beam frequency.

False alarms

  • Check the beam strength with the LEDs and re-aim.
  • Set different frequencies on units that are close together.
  • Keep plants trimmed out of the beam path.

No alarm output

  • Check the power at each end.
  • Check the relay wiring to the panel. The relay is not a monitored 10k output.

Common questions

No. It is a perimeter detector. For UL 325 entrapment protection use a monitored photo eye listed for the operator.

All four beams must break at once, so small animals and falling leaves do not trip it.

Yes. Run power to both the transmitter and the receiver.