Seco-Larm SD-991A-D1Q Mini No-Cut Electric Strike Manuals & Support

Seco-Larm SD-991A-D1Q

The Seco-Larm SD-991A-D1Q is a mini no-cut electric strike for metal frames and most cylindrical locksets. It runs on 12 VDC, draws 280 mA and is fail-secure.

It comes with a stainless no-cut plate and a silver aluminum low-cut plate. Static strength is 1,000 lb and it is tested to 250,000 cycles.

Buy the SD-991A-D1Q

Identify your model

The SD-991A-D1Q has a stainless keeper and two strike plates. The bronze low-cut plate SD-991RA-61Q/B is sold separately.

Key specs

Operating voltage 12 VDC
Current draw 280 mA
Mode Fail-secure
Static strength 1,000 lb
Endurance 250,000 cycles
Use Indoor

Manuals and documents

Installation Manual

Wiring Diagram

Spec Sheet

Troubleshooting

Strike does not release

  • Check the wiring and confirm the rated voltage at the strike while it is energized.
  • Low voltage at the strike means the wire is too small or the power supply is too small.
  • Check the keypad, exit button or controller that triggers the strike.

Door does not open when the strike releases

  • Check that the latch moves freely. Move the strike or add shims so the latch is not bound by door pressure.

Strike buzzes

  • Run a DC strike on a DC power supply, not AC.

Common questions

Not with the no-cut plate. The low-cut plate needs little cutting beyond the strike hole.

No. It is fail-secure only.

Yes. Order the SD-991RA-61Q/B.