Seco-Larm SL-1301-SAQ LED Strobe Light with Siren Manuals & Support

Seco-Larm SL-1301-SAQ

The Seco-Larm SL-1301-SAQ is an LED strobe light with a built-in 100 dB siren. It has 8 flash patterns, 10 vertical LED strips and runs on 9 to 24 VAC or VDC.

Current units have 41 LEDs; earlier units had 54. The siren can be turned on or off, and an optional 9 VDC battery keeps it working on power loss. It is rated IP55.

Buy the SL-1301-SAQ (5 options)

Identify your model

The model ends in the lens color: /A amber, /B blue, /C clear, /G green, /R red. The SAQ has 10 vertical LED strips and a siren opening. Conduit brackets: SL-1901-DAQ drop and SL-1901-JAQ box.

Key specs

LEDs 41 (earlier units 54), 10 vertical strips
Siren 100 dB, programmable
Operating voltage 9 to 24 VAC or VDC
Current draw Up to 720 mA, by pattern and siren
Flash patterns 8, plus duty cycle
Backup battery 9 VDC, optional, not included
IP rating IP55
Size 3-15/16 in dia. x 3-1/8 in

Manuals and documents

Installation Manual

Spec Sheet

Troubleshooting

Strobe does not light

  • Check the supply voltage at the leads and the polarity. Red is positive.
  • Check the trigger output on the panel or controller that powers the strobe.

Wrong flash pattern

  • Remove power, set the DIP switches for the pattern you want, then power up again. Patterns are read at power up.

Siren does not sound

  • Check the siren DIP switch setting, then cycle power.

Common questions

Yes. The siren is set with the DIP switches. Remove power before changing them.

100 dB.

Allow up to 720 mA with the siren on, depending on the pattern.