Seco-Larm SM-200Q Screw-Terminal Surface Contact Manuals & Support

Seco-Larm SM-200Q

The Seco-Larm SM-200Q is a screw-terminal surface-mount magnetic contact for alarm and access systems.

It has a 3/4 in gap, screw terminals under a cover and slotted mounting holes for gap adjustment. White (SM-200Q/W) or brown (SM-200Q/BR).

Buy the SM-200Q (3 options)

Identify your model

Each part is 2-1/2 in long with side mounting tabs and a terminal cover. The SM-300Q is the open loop version of the same body.

Key specs

Mount Surface, screw tabs
Gap 3/4 in
Loop Closed loop, N.O. reed
Connections Screw terminals with cover
Magnet Ferrite
Size 2-1/2 x 9/16 x 1/2 in
Contact rating 1.0 A at 10 VDC, 10 W max
Switch life 50 million cycles at 0.1 mA, 5 VDC
Operating temperature -15 to 160 °F

Manuals and documents

Installation Manual

Spec Sheet

Troubleshooting

Zone shows open with the door closed

  • Close the door and check the gap between switch and magnet. It must be inside the rated gap.
  • Line up the magnet with the switch. Use the included spacers if the parts sit at different heights.
  • Steel doors and frames weaken the magnet. Keep the gap smaller on steel or use a contact rated for steel doors.

Zone does not trip when the door opens

  • Set the panel zone for a closed loop (N.C.) device.
  • Check for a second magnet or other steel hardware near the switch.

False alarms

  • Check the wire connections and look for nicked leads.
  • A loose door that moves in the wind can open the loop. Use a wider gap contact on loose doors.

Common questions

Closed loop. The reed switch is closed when the magnet is next to it and opens when the door or window opens.

Install the switch and magnet on the protected side of the door or window so they cannot be reached from outside.

Yes. The manufacturer requires the terminal cover in all installations.