Seco-Larm SM-204Q Miniature Surface Contact Manuals & Support

Seco-Larm SM-204Q

The Seco-Larm SM-204Q is a miniature flange-type surface-mount magnetic contact for alarm and access systems.

It has a 1 in gap and 15 in leads from the center of the switch. The flange breaks off for a smaller fit, and it mounts with screws or the included tape. The SM-204MQ/W is the matching spare magnet.

Buy the SM-204Q (3 options)

Identify your model

SM-204Q/W is white and SM-204Q/BR is brown. Each part is 1-3/8 x 3/8 x 1/4 in with leads from the center. The SM-205Q has leads from the side.

Key specs

Mount Surface, screw or tape
Gap 1 in
Loop Closed loop, N.O. reed
Leads 15 in from center
Magnet Alnico 5
Size 1-3/8 x 3/8 x 1/4 in
Contact rating 1.0 A at 10 VDC, 10 W max
Switch life 50 million cycles at 0.1 mA, 5 VDC
Operating temperature -15 to 160 °F

Manuals and documents

Installation Manual

Spec Sheet

Troubleshooting

Zone shows open with the door closed

  • Close the door and check the gap between switch and magnet. It must be inside the rated gap.
  • Line up the magnet with the switch. Use the included spacers if the parts sit at different heights.
  • Steel doors and frames weaken the magnet. Keep the gap smaller on steel or use a contact rated for steel doors.

Zone does not trip when the door opens

  • Set the panel zone for a closed loop (N.C.) device.
  • Check for a second magnet or other steel hardware near the switch.

False alarms

  • Check the wire connections and look for nicked leads.
  • A loose door that moves in the wind can open the loop. Use a wider gap contact on loose doors.

Common questions

Closed loop. The reed switch is closed when the magnet is next to it and opens when the door or window opens.

Install the switch and magnet on the protected side of the door or window so they cannot be reached from outside.

Yes. The SM-204MQ/W is the white magnet only and fits the SM-204Q/W and SM-205Q/W.