Seco-Larm SM-226 Overhead Door Contacts Manuals & Support

Seco-Larm SM-226LQ

The Seco-Larm SM-226LQ is a floor-mount overhead door magnetic contact for alarm and access systems.

The switch sits in a low cast-aluminum housing on the floor and the magnet mounts on the door with an L-bracket. It has a 2-3/4 in gap, 24 in armored leads and an epoxy-sealed switch.

Buy the SM-226LQ (4 options)

Identify your model

SM-226LQ: closed loop. SM-226R-3Q and SM-226L-3Q: open/closed loop with 3 wires. The magnet is in a gray case on an L-bracket. SM-226RQ: closed loop with armored leads.

Key specs

Mount Floor, with magnet on L-bracket
Gap 2-3/4 in
Loop LQ: closed; -3Q: open/closed, SPDT
Leads 24 in armored
Housing Cast aluminum, IP66
Operating voltage 12 to 24 VDC
Switch life 50 million cycles at 0.1 mA, 5 VDC
Operating temperature -15 to 160 °F
Contact rating LQ: 1.0 A at 10 VDC; -3Q: 0.2 A at 10 VDC

Manuals and documents

Installation Manual

Spec Sheet

Troubleshooting

Zone shows open with the door closed

  • Close the door and check the gap between switch and magnet. It must be inside the rated gap.
  • Line up the magnet with the switch. Use the included spacers if the parts sit at different heights.
  • Steel doors and frames weaken the magnet. Keep the gap smaller on steel or use a contact rated for steel doors.

Zone does not trip when the door opens

  • Set the panel zone for a closed loop (N.C.) device.
  • Check for a second magnet or other steel hardware near the switch.

False alarms

  • Check the wire connections and look for nicked leads.
  • A loose door that moves in the wind can open the loop. Use a wider gap contact on loose doors.

Common questions

Closed loop. The reed switch is closed when the magnet is next to it and opens when the door or window opens.

Install the switch and magnet on the protected side of the door or window so they cannot be reached from outside.

The switch housing is low and curved for floor mounting, but keep it out of the main wheel path where possible.