Seco-Larm SM-407-5TQ/W Recessed Contact Manuals & Support

Seco-Larm SM-407-5TQ/W

The Seco-Larm SM-407-5TQ/W is a 3/8 in recessed magnetic contact for alarm and access systems.

It press-fits in a 3/8 in hole, has gold-plated screw terminals and a 3/4 in gap. The rare-earth magnet and iridium-plated reed switch suit sliding doors and windows where space is tight.

Buy the SM-407-5TQ/W

Identify your model

The SM-407-5TQ/W is a white 3/8 in press-fit switch with screw terminals on the end. The switch is 15/16 in long and the magnet 9/16 in.

Key specs

Mount 3/8 in press-fit, recessed
Gap 3/4 in
Loop Closed loop, N.O. reed
Connections Gold-plated screw terminals
Magnet Rare-earth neodymium
Contact rating 1.0 A at 10 VDC, 10 W max
Switch life 50 million cycles at 0.1 mA, 5 VDC
Operating temperature -15 to 160 °F

Manuals and documents

Spec Sheet

Troubleshooting

Zone shows open with the door closed

  • Close the door and check the gap between switch and magnet. It must be inside the rated gap.
  • Line up the magnet with the switch. Use the included spacers if the parts sit at different heights.
  • Steel doors and frames weaken the magnet. Keep the gap smaller on steel or use a contact rated for steel doors.

Zone does not trip when the door opens

  • Set the panel zone for a closed loop (N.C.) device.
  • Check for a second magnet or other steel hardware near the switch.

False alarms

  • Check the wire connections and look for nicked leads.
  • A loose door that moves in the wind can open the loop. Use a wider gap contact on loose doors.

Common questions

Closed loop. The reed switch is closed when the magnet is next to it and opens when the door or window opens.

Install the switch and magnet on the protected side of the door or window so they cannot be reached from outside.

A 3/8 in hole for both the switch and the magnet. Ribs on the parts hold them in the hole.