Seco-Larm SM-4105-LQ Steel-Door Recessed Contact Manuals & Support

Seco-Larm SM-4105-LQ/W / SM-4105-LQ/B

The Seco-Larm SM-4105-LQ is a UL listed 3/4 in recessed magnetic contact for steel-framed doors and windows, for closed loop circuits.

It has a 1 in gap, 18 in leads, a one-piece body and a rare-earth magnet. Ribs on the switch and magnet hold them in the drilled holes. White (/W) or brown (/B).

Buy the SM-4105-LQ/W / SM-4105-LQ/B (3 options)

Identify your model

Switch and magnet are each 15/16 in round and 1-3/16 in long with a lip. /W is white and /B is brown. The SM-4104-TQ/W is the same 3/4 in steel-door contact with screw terminals in place of leads.

Key specs

Mount 3/4 in recessed, press-fit
Gap 1 in, steel doors
Loop Closed loop, N.O. reed
Leads 18 in
Magnet Rare-earth neodymium
Contact rating 1.0 A at 10 VDC, 10 W max
Switch life 50 million cycles at 0.1 mA, 5 VDC
Operating temperature -15 to 160 °F

Manuals and documents

Installation Manual

Spec Sheet

Troubleshooting

Zone shows open with the door closed

  • Close the door and check the gap between switch and magnet. It must be inside the rated gap.
  • Line up the magnet with the switch face to face.
  • Steel doors and frames weaken the magnet. Keep the gap smaller on steel or use a contact rated for steel doors.

Zone does not trip when the door opens

  • Set the panel zone for a closed loop (N.C.) device.
  • Check for a second magnet or other steel hardware near the switch.

False alarms

  • Check the wire connections and look for nicked leads.
  • A loose door that moves in the wind can open the loop. Use a wider gap contact on loose doors.

Common questions

Closed loop. The reed switch is closed when the magnet is next to it and opens when the door or window opens.

Install the switch and magnet on the protected side of the door or window so they cannot be reached from outside.

Yes. It is rated for steel-framed doors and windows with a 1 in gap.