Seco-Larm SM-4302-LQ/W Rollerball Contact Manuals & Support

Seco-Larm SM-4302-LQ/W

The Seco-Larm SM-4302-LQ/W is a rollerball-type recessed magnetic contact for alarm and access systems.

The magnet and reed switch are in one housing with a 360 degree rollerball that travels 1/4 in. It has 18 in leads and suits sliding doors and windows.

Buy the SM-4302-LQ/W

Identify your model

The SM-4302-LQ/W is a white 3/4 in round switch with a rollerball tip and 18 in leads. The SM-4301-TQ/W is the plunger version.

Key specs

Type Rollerball plunger
Travel 1/4 in
Loop Closed loop, N.O. reed
Leads 18 in
Size 1-9/16 x 15/16 x 1-5/8 in
Contact rating 1.0 A at 10 VDC, 10 W max
Switch life 50 million cycles at 0.1 mA, 5 VDC
Operating temperature -15 to 160 °F

Manuals and documents

Installation Manual

Spec Sheet

Troubleshooting

Zone shows open with the door closed

  • Close the door and check the gap between switch and magnet. It must be inside the rated gap.
  • Line up the magnet with the switch. Use the included spacers if the parts sit at different heights.
  • Steel doors and frames weaken the magnet. Keep the gap smaller on steel or use a contact rated for steel doors.

Zone does not trip when the door opens

  • Set the panel zone for a closed loop (N.C.) device.
  • Check for a second magnet or other steel hardware near the switch.

False alarms

  • Check the wire connections and look for nicked leads.
  • A loose door that moves in the wind can open the loop. Use a wider gap contact on loose doors.

Common questions

No. The magnet is inside the housing. The door pushes the rollerball in.

Install the switch and magnet on the protected side of the door or window so they cannot be reached from outside.

The ball lets a sliding door roll over the switch without catching it.