Seco-Larm SM-433-TQ Concealed-Terminal Surface Contact Manuals & Support

Seco-Larm SM-433-TQ/W / SM-433-TQ/B

The Seco-Larm SM-433-TQ is a UL listed surface-mount magnetic contact for closed loop circuits. A cover hides the mounting screws, terminal block and wires.

It has a 1-1/4 in gap, gold-plated screw terminals and a rare-earth magnet. White (SM-433-TQ/W) or brown (SM-433-TQ/B).

Buy the SM-433-TQ/W / SM-433-TQ/B (2 options)

Identify your model

Switch and magnet are each 2 x 9/16 x 1/2 in with a snap-on cover over the terminals. /W is white and /B is brown.

Key specs

Mount Surface, screw
Gap 1-1/4 in
Loop Closed loop, N.O. reed
Connections Gold-plated screw terminals, covered
Magnet Rare-earth neodymium
Size 2 x 9/16 x 1/2 in each part
Contact rating 1.0 A at 10 VDC, 10 W max
Switch life 50 million cycles at 0.1 mA, 5 VDC
Operating temperature -15 to 160 °F

Manuals and documents

Installation Manual

Spec Sheet

Troubleshooting

Zone shows open with the door closed

  • Close the door and check the gap between switch and magnet. It must be inside the rated gap.
  • Line up the magnet with the switch face to face.
  • Steel doors and frames weaken the magnet. Keep the gap smaller on steel or use a contact rated for steel doors.

Zone does not trip when the door opens

  • Set the panel zone for a closed loop (N.C.) device.
  • Check for a second magnet or other steel hardware near the switch.

False alarms

  • Check the wire connections and look for nicked leads.
  • A loose door that moves in the wind can open the loop. Use a wider gap contact on loose doors.

Common questions

Closed loop. The reed switch is closed when the magnet is next to it and opens when the door or window opens.

Install the switch and magnet on the protected side of the door or window so they cannot be reached from outside.

No. The cover hides the screws, terminal block and wires once it is snapped on.