Seco-Larm SM-4601-LQ Industrial Wide-Gap Contact Manuals & Support

Seco-Larm SM-4601-LQ

The Seco-Larm SM-4601-LQ is an industrial wide-gap surface-mount magnetic contact for alarm and access systems.

It has a 3 in gap, an aluminum housing sealed to IP65 and 36 in leads in armored cable. The SM-4601-L3Q is the open/closed loop (Form C) version.

Buy the SM-4601-LQ (2 options)

Identify your model

Both parts are aluminum blocks, 3 x 1 x 1/2 in, with a mounting bracket. The LQ has 2 wires; the L3Q has 3 wires (NO/NC/COM).

Key specs

Mount Surface, with bracket
Gap 3 in
Loop LQ: closed loop, SPST; L3Q: open/closed, SPDT
Leads 36 in armored
Housing Aluminum, IP65
Magnet Rare-earth neodymium
Contact rating 1.0 A at 10 VDC, 10 W max
Switch life 50 million cycles at 0.1 mA, 5 VDC
Operating temperature -15 to 160 °F

Manuals and documents

Installation Manual

Spec Sheet

Troubleshooting

Zone shows open with the door closed

  • Close the door and check the gap between switch and magnet. It must be inside the rated gap.
  • Line up the magnet with the switch. Use the included spacers if the parts sit at different heights.
  • Steel doors and frames weaken the magnet. Keep the gap smaller on steel or use a contact rated for steel doors.

Zone does not trip when the door opens

  • Set the panel zone for a closed loop (N.C.) device.
  • Check for a second magnet or other steel hardware near the switch.

False alarms

  • Check the wire connections and look for nicked leads.
  • A loose door that moves in the wind can open the loop. Use a wider gap contact on loose doors.

Common questions

Closed loop. The reed switch is closed when the magnet is next to it and opens when the door or window opens.

Install the switch and magnet on the protected side of the door or window so they cannot be reached from outside.

Yes. The housing is sealed to IP65 and the leads are in armored cable.