Seco-Larm SR Series Relay Modules Manuals & Support

Seco-Larm SR-1212-C7ALQ / SR-2112-C7AQ/10 / SR-2206-C5AQ

The Seco-Larm SR relay modules put pre-wired relays on a small board with screw terminals. The SR-1212-C7ALQ has two 7 A SPDT relays and triggers on 3 to 24 VDC at 1 mA.

The SR-2112-C7AQ/10 is a breakaway 10-pack of single 7 A SPDT modules on 12 or 24 VDC, and the SR-2206-C5AQ has one 5 A DPDT relay on 6 or 12 VDC.

Buy the SR-1212-C7ALQ / SR-2112-C7AQ/10 / SR-2206-C5AQ (5 options)

Identify your model

SR-1212-C7ALQ: 2 relays, high sensitivity. SR-1212-C2ALQ: earlier 2 A DPDT model, replaced by the C7ALQ. SR-2112-C7AQ/10: 10 modules on a breakaway board. SR-2206-C5AQ: DPDT, auto-sensing. SR-2212-C5AQ: one 5 A DPDT relay with a 12 or 24 VDC trigger.

Key specs

SR-1212-C7ALQ 12/24 VDC supply, 3 to 24 VDC trigger, 2 x 7 A SPDT, 60 mA
SR-2112-C7AQ/10 12/24 VDC, 1 x 7 A SPDT, 35 mA at 12 VDC
SR-2206-C5AQ 6/12 VDC, 1 x 5 A DPDT, auto-sensing
Contact rating 7 A or 5 A at 250 VAC / 30 VDC
Connections Screw terminals

Manuals and documents

Installation Manual

Spec Sheet

Troubleshooting

Relay does not click

  • Check the supply voltage and the jumper setting for 12 or 24 VDC.
  • Check the trigger voltage is inside the rated range.

Load does not switch

  • Check the load wiring on COM and N.O. or N.C.
  • Keep the load under the contact rating.

Common questions

The SR-1212 high sensitivity modules trigger on 3 to 24 VDC at 1 mA.

Yes. The SR-2112-C7AQ/10 boards snap apart into single modules.

The SR-1212-C7ALQ.