Seco-Larm SS-074Q/BG Double-Button Holdup Switch Manuals & Support

Seco-Larm SS-074Q/BG

The Seco-Larm SS-074Q/BG is a double-button momentary holdup switch for alarm panels. Both buttons must be pressed together, which stops most accidental alarms.

It is N.O. with push-to-close operation and silver-plated SPST contacts in a metal case. It comes pre-wired for quick installation.

Buy the SS-074Q/BG

Identify your model

The SS-074Q/BG is a small metal box with two buttons side by side and pre-wired leads.

Key specs

Type Holdup switch, double button
Operation Momentary, N.O., push to close
Contacts Silver-plated SPST
Rating 1 A at 25 VDC
Case Metal, pre-wired

Manuals and documents

Spec Sheet

Troubleshooting

Panel does not see the alarm

  • Press both buttons fully at the same time.
  • Set the panel zone for a N.O. holdup device, or use an end-of-line resistor as the panel requires.

False holdup alarms

  • Mount it where knees or bags cannot press both buttons.

Common questions

Both must be pressed at once, so a bump on one button does not set off an alarm.

N.O. It closes when both buttons are pressed.

No. It is momentary. Use the panel zone to latch the alarm.