Seco-Larm ST-BD01Q Low-Voltage Battery Cutoff Manuals & Support

Seco-Larm ST-BD01Q

The Seco-Larm ST-BD01Q disconnects a 12 or 24 VDC backup battery before it deep discharges. It wires between the transformer, the power supply or panel, and the battery.

Cutoff is near 9.6 VDC on 12 VDC or 19.6 VDC on 24 VDC and adjusts. The relay is rated 7 A at 30 VDC. A master switch connects or disconnects battery and AC.

Buy the ST-BD01Q

Identify your model

The ST-BD01Q is 2-3/8 x 1-3/4 x 7/8 in. Green LED: AC. DC LED: red on 12 VDC, blue on 24 VDC.

Key specs

Battery 12 or 24 VDC
Cutoff 9 to 10 VDC or 19.2 to 20.3 VDC, adjustable
Relay 7 A at 30 VDC
AC input 12 to 18 VAC (12 V) or 24 to 30 VAC (24 V)
Operating temperature -40 to 149 °F

Manuals and documents

Installation Manual

Spec Sheet

Troubleshooting

Battery does not connect

  • Turn the master switch on.
  • Check the battery is above the restore point.

Cuts off too early

  • Turn the cutoff point down within the range.

Common questions

It keeps a backup battery from deep discharge, which can ruin it.

Yes. It selects 12 or 24 VDC.

To the DC output of the power supply or panel.