Security Brands Ridge 14-500 Wireless Keypads Manuals & Support

Security Brands 14-500 / 14-500T / 14-HD500 / 14-REC20

The Security Brands Ridge 14-500 is a battery powered wireless keypad that talks to a Ridge Transceiver over a 433 MHz two-way link, up to 500 ft. No trenching is needed.

It holds 500 four-digit codes with a personal master code, limited-use codes and latch mode. The transceiver runs on 12 to 24 VAC or VDC with relay time from 1 to 999 seconds.

Buy the 14-500 / 14-500T / 14-HD500 / 14-REC20 (4 options)

Identify your model

14-500: keypad and transceiver kit. 14-500T: keypad only. 14-HD500: HD keypad kit. 14-REC20: Ridge Transceiver. 14-R433: Ridge remote. Up to 40 keypads and remotes pair to one transceiver. 14-RTE433: request-to-exit kit with transceiver. 14-RTE433T: post mount request-to-exit station.

Key specs

Codes 500, four digits
Radio 433 MHz two-way, up to 500 ft
Keypad power One 9 V battery
Transceiver power 12 to 24 VAC or VDC
Relay 2 A at 30 VDC, 1 to 999 seconds
Operating temperature -15 to 158 °F

Manuals and documents

Installation Manual

Quick Start

Spec Sheet

Troubleshooting

Valid code does not open the gate

  • Check that the relay output is wired to the operator open input.
  • Check the relay time setting.

Keypad is dead

  • Check the supply voltage at the keypad terminals.

Keypad does not reach the transceiver

  • Replace the 9 V battery.
  • Pair the keypad to the transceiver again.

Common questions

No. Mount it inside a weatherproof enclosure.

Yes, when paired with two Ridge Transceivers.

Yes. Change the factory master code during setup and record the new one.