Part of the EZ Parts Finder: pick a part on the diagram or use the list below.
This interactive parts diagram is for the Linear SWG swing gate operator. Click a part in the photo to see its number, or scroll down to the list. The main view shows the operator and crank arm. The gearbox view covers the reducer, torque limiter, shafts and bearings. The control area view shows the Apex board and loop detector. A parts list drawing is included too.
Identify your model
Linear builds the SWG in single phase (115, 208 or 230 V) and three phase (208, 230 or 460 V) versions, each in 1/2, 3/4 and 1 HP. Use the wiring listing that matches your model, voltage and horsepower. A wiring print is on the label inside the operator cover. Have the model and serial number ready when you order.
Operator and manuals
- Operator: LINEAR OSCO SWG-211 1/2HP SWING GATE OPERATOR
- SWG installation manual (PDF)
- SWG electrical drawing (PDF)
- SWG mounting drawing (PDF)
Most ordered parts
- Detector de bucle EDI LMA-1800 (LMA-1800)
- Lineal 620-101293 Apex II (620-101293)
- Interruptor de límite lineal 2500-764 (2500-764)
- Kit de alarma Linear 2500-867 - Pre-Apex (2500-867)
- Motor lineal 2500-2311 de 1 HP, 115 V, monofásico (2500-2311)
- Placa de control lineal APEX OSCO 2500-2393 (2500-2393)
- Motor lineal 2500-2307, 1/2 HP, 115 V (2500-2307)
- Motor lineal 2500-2308, 1/2 HP, 208/230 V, monofásico (2500-2308)
Parts list by assembly
Main
| Part number | Part |
|---|---|
| 2500-2311 | Motor lineal 2500-2311 de 1 HP, 115 V, monofásico |
| 2120-136-UPS | Manivela lineal OSCO 2120-136-UPS de acero de 1-1/8" SWG Ups |
Gearbox
Control Area
| Part number | Part |
|---|---|
| 620-101293 | Lineal 620-101293 Apex II |
| 106604 | Lineal 106604: Antena local |
| LMA-1800 | Detector de bucle EDI LMA-1800 |
| 2500-2393 | Placa de control lineal APEX OSCO 2500-2393 |
| 2510-429 | ARNÉS Linear 2510-429 SWR/SWC 230 V APEX |
Common questions
How far can the SWG open a gate?
Linear lists a maximum opening angle of about 95 degrees, depending on gate width.
How do I adjust the SWG torque limiter?
Turn the power disconnect off first. Bend the locking tabs away from the nut, turn the nut one flat (1/6 turn) at a time, clockwise for more torque, then bend the tabs back. Current sensing must trip before the torque limiter slips.
What lubrication does the SWG need?
Grease the bearings with fittings at least twice a year with a lithium complex NLGI 2 grease, and lightly oil the arm pivot points with light machine oil.