AES e-Loop Commercial Wireless Vehicle Sensor Manuals & Support

AES EL00C / EL00C-K / EL00C-RAD / EL00C-RAD-K

The AES e-Loop Commercial is a wireless vehicle sensor that bolts to the middle of the lane. It signals the e-Trans transceiver, whose relay wires to the gate operator. No saw cuts or trenching.

The EL00C is for exit mode. The EL00C-RAD adds radar for presence mode, so the relay stays latched while a vehicle is over the sensor.

Buy the EL00C / EL00C-K / EL00C-RAD / EL00C-RAD-K (4 options)

Identify your model

EL00C and EL00C-RAD: sensor only. EL00C-K and EL00C-RAD-K: kits with the ETRANS50 transceiver. The sensor mounts with dyna bolts.

Key specs

Detection 3-axis magnetometer; radar on RAD models
Radar 60 degree field, 2 to 6.5 ft
Radio 433.39 MHz, 128-bit AES
Transceiver ETRANS50, 10 to 36 VDC, 1 A relay
Mode Exit (EL00C), presence (EL00C-RAD)

Manuals and documents

Installation Manual

Other documents

Troubleshooting

Sensor does not trigger

  • Code the sensor to the transceiver again.
  • Recalibrate with no vehicle near the sensor.
  • Check the sensor batteries.

Error LEDs

  • Run the test mode and compare the LEDs to the AES LED display guide.

Common questions

Use the EL00C for exit. Use the EL00C-RAD when the gate must stay open while a vehicle is over the sensor.

No. AES says not to use presence mode as a personal safety device.

Inside the operator or a weatherproof box. AES rates it for indoor use.