Diablo DSP-15 Board Mount Vehicle Detector Manuals & Support

Diablo DSP-15-LVT / DSP-15-LVM / DSP-15-LVF

The Diablo Controls DSP-15 is the circuit board version of the DSP-10. It is a single channel loop detector with two relay outputs, for mounting inside a control box.

It runs on 10 to 30 VDC or 10 to 28 VAC. Output A is fail-safe or fail-secure by jumper. Output B runs presence, entry pulse, exit pulse or loop fail.

Buy the DSP-15-LVT / DSP-15-LVM / DSP-15-LVF (3 options)

Identify your model

The board is 2.90 x 4.125 in. LVT: pluggable screw terminal block. LVM: 10-pin male Molex. LVF: 10-pin female Molex.

Key specs

Power 10 to 30 VDC or 10 to 28 VAC
Relays 2, 3 A
Sensitivity 10 levels plus boost
Timing 2 s delay; 0, 2, 5 or 10 s extension
Loop inductance 20 to 2,000 µH
Operating temperature -35 to 165 °F

Manuals and documents

Installation Manual

Spec Sheet

Other documents

Troubleshooting

Gate does not open or reopen

  • Check the detect LED when a vehicle is on the loop.
  • Raise the sensitivity one step at a time.

Detector stays in detect

  • Check the loop and lead-in for a break or short to ground.
  • Reset the detector so it retunes.

Random detects

  • Set nearby detectors to different frequencies.
  • Check that the lead-in is twisted and the saw cut is sealed.

Common questions

Match the control box: LVT for a terminal block, LVM for a male Molex, LVF for a female Molex.

Yes, power drops of about 3 seconds.

Use direct-burial loop wire such as 16 AWG XLPE, not THHN. Twist the lead-in about 6 turns per foot and seal saw cuts with loop sealant.