LiftMaster INSL24UL Industrial Slide Gate Operator Manuals & Support

LiftMaster INSL24UL

The LiftMaster INSL24UL is a 24 VDC continuous duty industrial slide gate operator for gates up to 70 ft and 2,200 lb. It drives #40 chain through an oil bath gearbox.

Battery backup, soft start and stop, myQ and a Security+ 2.0 receiver are built in. It is UL 325 listed for Class II, III and IV.

Buy the INSL24UL

Identify your model

INSL24UL: comes with 30 ft of #40 chain, an LMRRUL photo eye and an S505AL edge. The MRIN riser kit lets it retrofit an existing pad.

Key specs

Max gate 70 ft, 2,200 lb
Motor 24 VDC continuous duty
Speed 0.5 to 1 ft/s
Power 115 or 230 VAC single phase
Cabinet 14 ga steel, NEMA 3R
UL 325 Class II, III and IV

Manuals and documents

Installation Manual

Spec Sheet

Other documents

Troubleshooting

Operator does not run

  • Check power and the fuses.
  • Check the board display or LEDs for a fault.
  • Check that the safety inputs are not active.

Gate stops or reverses

  • Check the gate moves freely by hand.
  • Check photo eyes and edges.
  • Check the force and limit settings.

Common questions

Yes, with the 3PHCONV transformer kit.

The S505AL edge needs a wireless edge kit such as the LMWEKITU to mount on the moving gate.

A riser kit to mount the operator on an existing pad.