Miller Edge RBand Wireless Gate Edge System Manuals & Support

Miller Edge RB-G-K10

The Miller Edge RBand is a monitored wireless link between a 10K sensing edge on a gate and the gate operator. It meets the 2016 UL 325 rules for monitored devices.

The receiver has two channels for up to six transmitters. It runs on 12 to 24 VAC or VDC, and each transmitter runs about two years on two 3.6 V AA lithium batteries.

Buy the RB-G-K10 (3 options)

Identify your model

RB-G-K10 is the kit with the RB-G-RX10 receiver and one RB-TX10 transmitter. Transmitters are also sold alone.

Key specs

Frequency	916 MHz
Range	50 ft nominal, 100 ft in ideal conditions
Transmitters	Up to 6 on 2 channels
Edge input	10K monitored edge
Receiver outputs	10K and NC
Receiver power	12 to 24 VAC or VDC, 100 mA max
Transmitter power	2 x 3.6 V AA lithium, about 2 years
Operating temperature	-40 to 140 °F
Approvals	2016 UL 325 recognized component

Manuals and documents

Installation Manual

RBand RB-G-K10 Installation Instructions
5 pages View PDF: RBand RB-G-K10 Installation Instructions (opens in a new tab)

Spec Sheet

RB-G-K10 Spec Sheet
1 page View PDF: RB-G-K10 Spec Sheet (opens in a new tab)
RBand for Doors RB-P-K10 Spec Sheet
2 pages View PDF: RBand for Doors RB-P-K10 Spec Sheet (opens in a new tab)

Troubleshooting

Turn on any other wireless devices on site before pairing. The receiver picks the quietest channel.

Receiver LEDs

R1 or R2 on with no transmitters: not programmed yet.
R1 or R2 on after programming: fault on that channel.
R3 on: low battery in a transmitter.
CHECK flashes every 5 seconds: both channels programmed.

Normally closed operators

Set DIP switch 4 on and wire the switched test power to A TEST and COM.

Common questions

Up to six transmitters on two channels, three per channel.

A Miller Edge 10K monitored edge (blue band).

Two 3.6 V AA lithium batteries, about two years.

Buy the Miller Edge RBand Wireless Gate Edge System

Miller Edge RB-G-K10C RBand monitored wireless gate edge kit

Puerta inalámbrica Miller Edge con monitorización RBAND, combinación TX/RX

Miller Edge RB-TX10C RBand monitored wireless edge transmitter

Transmisor de puerta inalámbrico monitoreado por banda RB de Miller Edge

Miller Edge RB-G-RX RBand monitored wireless gate receiver

Receptor de puerta inalámbrico monitoreado por banda RB de Miller Edge

Safety devices and accessories

Miller Edge ME-120-5-2016 10K monitored safety edge

Miller Edge ME-120-5-2016 10K monitored safety edge - view 2

Borde de seguridad Miller Edge ME120 de 5 pies, estilo UL 10K actual

Miller Edge RBand Wireless Gate Edge Instructions