Nice Apollo 636 Control Board Manuals & Support

Nice Apollo 636US / CBOX636

The Nice Apollo 636 is the 12 VDC control board for the 1500 farm and ranch swing gate opener. It replaced the 635 and works in single and dual gate systems.

It has DIP switch settings, timer to close and current sensitivity adjustments, limit LEDs and an emergency bypass connector to open the gate if controls are locked.

Buy the 636US / CBOX636 (2 options)

Identify your model

The 636US comes alone or in the CBOX636 with a 318N receiver and ABF/A antenna. A jumper plug in the SLAVE port sets it for single gate use.

Key specs

Power 12 VDC battery system
Use 1500 farm and ranch swing opener
Fuses 3 A accessory fuses; 15 A emergency bypass fuse
Adjustments Timer to close, current sensitivity, DIP switches

Manuals and documents

Installation Manual

Service Bulletin

Troubleshooting

Single gate timer to close does not work

  • Keep the jumper plug in the SLAVE port and DIP switch 4 (SLAVE DISABLE) on.

Dual gate setup

  • Remove the SLAVE jumper plug and set DIP switch 4 off.

Seeing limit LEDs

  • Press and hold the LED ENABLE button. With the jumper plug in, both SLAVE LEDs stay lit.

Opening the gate in an emergency

  • Plug the motor harness into the emergency bypass connector briefly to open the gate. Unplug it before the gate binds. A blown 15 A fuse protects the board.

Common questions

Yes. The 636 replaces the 635 and works for single or dual gates.

Remove the jumper plug from the SLAVE port and set DIP switch 4 off.

It opens the gate when the controls are locked. It only runs the motor open, with no limits, so unplug it in time.