Optex OVS-01GT Vehicle Presence Sensor Manuals & Support

Optex OVS-01GT

The Optex OVS-01GT is an above-ground vehicle presence sensor for gates, barrier arms and industrial doors. It combines 24 GHz microwave and ultrasonic sensing and replaces a cut loop.

It mounts 2 to 3 ft off the ground on a pole or post, detects stopped and moving vehicles from 6.5 to 18 ft, ignores most people and has a built-in heater for snow.

Buy the OVS-01GT

Identify your model

The OVS-01GT is a small sensor head with a two-color operation LED. The newer OVS-02GT is the Virtual Loop 2.0.

Key specs

Technology 24 GHz microwave (FMCW) plus 56 kHz ultrasonic
Range 6.5 to 18 ft, 8 settings
Mounting 2 to 3 ft above ground
Power 12 to 24 VDC
Current 80 mA, 200 mA with heater at 24 VDC
Output Relay, 30 VDC 0.3 A, NO or NC
Response time 500 ms
Sensitivity 5 settings

Manuals and documents

Installation Manual

Quick Start

Spec Sheet

Troubleshooting

Operation LED off

  • Check for 12 to 24 VDC and correct polarity.

Detection not reaching the operator

  • Check the relay wiring and pick NO or NC to match the operator input.

Calibration error (red and blue alternate)

  • Remove people, flags, banners or weeds from the area and run calibration again.

Gate arm or ground detected

  • Raise the sensor, level it and aim it away from the arm or ground.

Common questions

Yes. It detects stopped and moving vehicles.

2 to 3 ft above the ground on a pole or post near the operator.

12 to 24 VDC. Allow 200 mA at 24 VDC with the heater on.