Seco-Larm E-960 Twin Photobeam Detectors Manuals & Support

Seco-Larm E-960-D90GQ / D90Q / D190Q / D290Q

The Seco-Larm E-960 series are twin-beam transmitter and receiver pairs for perimeter detection. Both beams must break to trigger, which cuts false alarms from leaves and birds.

They run on 12 to 30 VAC or VDC, have laser alignment, anti-frost heating and a tamper switch. The E-960-D90GQ adds monitored N.C. and 10k ohm outputs.

Buy the E-960-D90GQ / D90Q / D190Q / D290Q (4 options)

Identify your model

The number is the outdoor range: D90 is 90 ft, D190 is 190 ft, D290 is 290 ft. GQ models have a monitored output. The E-960ACC-CVR is the replacement cover.

Key specs

Outdoor range D90: 90 ft; D190: 190 ft; D290: 290 ft
Beams Twin
Operating voltage 12 to 30 VAC or VDC, non-polarized
Current draw 150 mA max (D90GQ)
Output SPDT relay, 1 A at 30 VAC/VDC
Monitoring D90GQ: N.C. or 10k ohm
Alignment Built-in laser
Operating temperature -13 to 131 °F

Manuals and documents

Installation Manual

Spec Sheet

Troubleshooting

Transmitter LED does not light

  • Check 12 to 30 VAC or VDC at the transmitter.

Receiver never trips

  • Check the voltage at the receiver.
  • Clean the covers.
  • Both beams must be blocked at the same time to trip.

LED trips but no output

  • Check the wiring from the relay to the panel. An overloaded relay contact can stick.

Common questions

Both beams must be blocked at once, so small objects like leaves or birds do not cause alarms.

It is a perimeter detector. For UL 325 gate entrapment protection use a monitored photo eye listed for the operator.

Use the built-in laser to line up the transmitter and receiver, then fine tune with the LEDs.