Seco-Larm SK-3523-SDQ Heavy-Duty Outdoor Keypad Manuals & Support

Seco-Larm SK-3523-SDQ

The Seco-Larm SK-3523-SDQ is a heavy-duty outdoor stand-alone keypad with a stainless faceplate and coated steel back for gates and fences. It holds 210 user codes of 4 or 5 digits.

It runs on 12 to 24 VAC/VDC. Two Form C relays are rated 12 A at 14 VDC, each set from 1 to 99 seconds or toggle. It has egress and door sensor inputs.

Buy the SK-3523-SDQ

Identify your model

The SK-3523-SDQ has backlit keys and overhead LEDs. It is code only with no card reader. Three wrong codes lock it out for 55 seconds.

Key specs

Users 210 codes, 4 or 5 digits
Operating voltage 12 to 24 VAC/VDC
Relays 2, Form C, 12 A at 14 VDC
Output time 1 to 99 seconds or toggle
Inputs Egress, door sensor
Tamper N.C., 3 A at 125/250 VAC

Manuals and documents

Installation Manual

Spec Sheet

Troubleshooting

Lock does not release on a good code

  • Check that the lock wire is on the correct relay terminal: N.O. for fail-secure, N.C. for fail-safe.
  • Install the diode across a DC lock or a varistor across an AC lock, unless the lock has its own protection.

Keypad is dead

  • Check the supply voltage at the power leads.

Keypad will not accept codes

  • Wait 55 seconds. Three wrong codes lock the keypad out.

Common questions

Yes. Change the factory master code during setup and record the new one.

No. It is code only. See the SK-3133-PPQ for a keypad with prox.

Yes. It has two relays with separate codes.