Seco-Larm SL-1301-BAQ LED Strobe Light Manuals & Support

Seco-Larm SL-1301-BAQ

The Seco-Larm SL-1301-BAQ is an LED strobe light with 8 flash patterns, adjustable flash speed and an optional 9 VDC backup battery. It runs on 9 to 24 VAC or VDC.

Vertical LED strips make it visible from the sides. Current units have 26 LEDs; earlier units had 32. It wires with 2 leads and has reverse polarity protection.

Buy the SL-1301-BAQ (5 options)

Identify your model

The model ends in the lens color: /A amber, /B blue, /C clear, /G green, /R red. The BAQ has 5 vertical LED strips. The SAQ adds a siren. Conduit brackets: SL-1901-DAQ drop and SL-1901-JAQ box.

Key specs

LEDs 26 (earlier units 32), 5 vertical strips
Operating voltage 9 to 24 VAC or VDC
Current draw 70 to 350 mA, by setting
Flash patterns 8, plus duty cycle
Flash speed 80 to 160 per minute, adjustable
Backup battery 9 VDC, optional, not included
IP rating IP66
Size 3-15/16 in dia. x 3-1/8 in

Manuals and documents

Installation Manual

Spec Sheet

Troubleshooting

Strobe does not light

  • Check the supply voltage at the leads and the polarity. Red is positive.
  • Check the trigger output on the panel or controller that powers the strobe.

Wrong flash pattern

  • Remove power, set the DIP switches for the pattern you want, then power up again. Patterns are read at power up.

Common questions

Remove power, set the DIP switches, then power up. DIP switch 4 sets the duty cycle on patterns 1, 2 and 5.

Yes. One of the 8 patterns is steady on.

No. The 9 VDC battery is optional and keeps the light working when power is lost.