Seco-Larm SM-4004 Capsule Surface Contacts Manuals & Support

Seco-Larm SM-4004

The Seco-Larm SM-4004 is a capsule-type miniature surface-mount magnetic contact for alarm and access systems.

Each part is a 1 in capsule that mounts with tape. The SM-4004-TQ/W has gold-plated screw terminals and a 1 in gap; the SM-4004-LQ/W has 18 in leads from the center and a 3/4 in gap.

Buy the SM-4004 (2 options)

Identify your model

Both are white capsules, 1 x 3/8 x 1/4 in. TQ has screw terminals on the side; LQ has wire leads.

Key specs

Mount Surface, tape
Gap TQ: 1 in; LQ: 3/4 in
Loop Closed loop, N.O. reed
Connections TQ: screw terminals; LQ: 18 in leads
Magnet Rare-earth neodymium
Size 1 x 3/8 x 1/4 in
Contact rating 1.0 A at 10 VDC, 10 W max
Switch life 50 million cycles at 0.1 mA, 5 VDC
Operating temperature -15 to 160 °F

Manuals and documents

Installation Manual

Spec Sheet

Troubleshooting

Zone shows open with the door closed

  • Close the door and check the gap between switch and magnet. It must be inside the rated gap.
  • Line up the magnet with the switch. Use the included spacers if the parts sit at different heights.
  • Steel doors and frames weaken the magnet. Keep the gap smaller on steel or use a contact rated for steel doors.

Zone does not trip when the door opens

  • Set the panel zone for a closed loop (N.C.) device.
  • Check for a second magnet or other steel hardware near the switch.

False alarms

  • Check the wire connections and look for nicked leads.
  • A loose door that moves in the wind can open the loop. Use a wider gap contact on loose doors.

Common questions

Closed loop. The reed switch is closed when the magnet is next to it and opens when the door or window opens.

Install the switch and magnet on the protected side of the door or window so they cannot be reached from outside.

With the included double-sided tape. Clean the surface first so the tape holds.