Seco-Larm ST-1206 and ST-2406 Power Supply/Chargers Manuals & Support

Seco-Larm ST-2406-2AQ / 3AQ / 3AEQ / 5AQ / 7AQ / 10AQ

The Seco-Larm ST-2406 boards are power supply/chargers with a selectable 6, 12 or 24 VDC output. They run from a separate transformer and charge a backup battery.

The output is regulated and filtered, and the board switches to the battery when power is lost. Models range from 1.5 A to 9 A continuous. The ST-2406-3AEQ comes in a steel enclosure.

Buy the ST-2406-2AQ / 3AQ / 3AEQ / 5AQ / 7AQ / 10AQ (7 options)

Identify your model

The number after the dash is the peak current: 2AQ 1.5 A, 3AQ 2.5 A, 5AQ 4 A, 7AQ 7 A and 10AQ 9 A continuous. 3AEQ: 3AQ in an enclosure for two 4 Ah or one 7 Ah battery. The ST-1206-1.5AQ is the 6 or 12 VDC model, 1.5 A continuous.

Key specs

Output 6, 12 or 24 VDC, selectable
Continuous current 1.5 A to 9 A by model
Input Separate transformer, see manual
Battery Built-in charger, switches over on power loss
Protection Short circuit, thermal, fused charger
Indicators AC and output LEDs

Manuals and documents

Installation Manual

Spec Sheet

Troubleshooting

No output

  • Check the AC input and the fuse.
  • Check that the output voltage is set for the devices you power.

Devices drop out under load

  • Add up the current of every device. Keep the total under the rated output.
  • Use larger wire on long runs to cut voltage drop.

Battery does not charge

  • Check the battery fuse and polarity.
  • A deeply drained battery may need to be replaced.

Common questions

It depends on the model and output voltage. See the transformer table in the manual. ST-UV open-frame transformers are listed there.

Yes. It keeps a backup battery charged and switches to it when power is lost.

No. The transformer is sold separately.