Linear HSLG Single Phase Parts Diagram and Replacement Parts

Part of the EZ Parts Finder: pick a part on the diagram or use the list below.

This interactive diagram covers the Linear HSLG single phase slide gate operator. Click a part to see its part number, or find it in the list that follows. Layers walk through the pulleys and motor, the brake, the control box, the clutch, the limit box and the output shaft. Single phase HSLG motors and brakes are voltage specific, so check your motor plate first.

Identify your model

Linear builds the HSLG in single phase versions at 115, 208 and 230 V, in 1/2, 3/4 and 1 HP. A wiring print is on the label inside the operator cover. The HSLG parts lists split the controller parts into single phase and three phase, and only single phase models use the dust cover. Note your model and serial number before you order.

Related models: Linear HSLG Three Phase

Operator and manuals

Most ordered parts

Parts list by assembly

Main

Pulley

Brake

Control Box

Clutch

Limit Box

Output Shaft

Common questions

How do I disconnect the HSLG to move the gate by hand?

The disconnect is at the center bottom of the cabinet. Pull the spring loaded shifter lever straight toward you until the locking lever snaps in behind it. To re-engage, move the locking lever to the right. Limit settings are not affected.

How often should the HSLG be lubricated?

Linear says to grease the bearings at least twice a year with a lithium complex NLGI 2 grease. The motors have sealed bearings and need no lubrication.

How much slack should the drive chain have?

About 1/4 in to 3/8 in of slack per foot of drive chain is acceptable. Inspect, clean and wipe the chain with a lightly oiled rag every six months.