AES e-Loop Mini Wireless Vehicle Sensor Manuals & Support

AES EL00M / EL00M-K / EL00M-RAD / EL00M-RAD-K

The AES e-Loop Mini is a wireless vehicle sensor for residential gates. It bolts to the driveway and signals the e-Trans transceiver, which opens the gate. No saw cuts are needed.

It uses a 3-axis magnetometer and sends over 433.39 MHz with 128-bit AES encryption, up to 150 ft to the transceiver. It runs on 2 AA lithium batteries.

Buy the EL00M / EL00M-K / EL00M-RAD / EL00M-RAD-K (4 options)

Identify your model

EL00M: exit mode sensor. EL00M-K: kit with the ETRANS50 transceiver. EL00M-RAD and EL00M-RAD-K: presence mode with radar, discontinued.

Key specs

Detection 3-axis magnetometer
Detection diameter About 5 ft
Radio 433.39 MHz, 128-bit AES
Range to transceiver Up to 150 ft
Power 2 x 1.5 V AA lithium
Mode Exit (EL00M), presence with radar (EL00M-RAD)

Manuals and documents

Installation Manual

Other documents

Troubleshooting

Sensor does not trigger

  • Code the sensor to the transceiver again.
  • Recalibrate with no vehicle near the sensor.
  • Check the sensor batteries.

Error LEDs

  • Run the test mode and compare the LEDs to the AES LED display guide.

Common questions

No. The sensor bolts to the surface and talks to the transceiver by radio.

No. AES says not to use presence mode as a personal safety device.

AES lists the e-Loop Commercial EL00C-RAD as the updated version.