BEA BODYGUARD-T Presence Sensor Manuals & Support

BEA 10BODYGUARDT

The BEA BODYGUARD-T is an overhead presence sensor for automatic swing and folding doors. It stops a closed door from opening and an open door from closing when someone is in the zone.

It mounts on the door, is internally monitored and can be externally monitored, and runs on 12 to 24 VAC or VDC.

Buy the 10BODYGUARDT

Identify your model

The BODYGUARD-T is a long black anodized bar, 11.8 in long. The Bodymount block sets 0°, 5° or 10° tilt. 10URC: rain cover for exterior doors. 10LO21: LO21 lock-out relay module for swing doors.

Key specs

Technology Active infrared presence
Mounting height 9 ft max; 6 ft 6 in to 8 ft recommended
Tilt 5° or 10°; 0° with Bodymount
Power 12 to 24 VAC or VDC
Monitoring input 12 to 30 VDC, active low
Output Relay, 1 A
Hold time 0.5 to 9 seconds
Size 11.8 x 1.9 x 1.9 in

Manuals and documents

Installation Manual

Spec Sheet

Service Bulletin

Other documents

Troubleshooting

Will not set up at power up

  • Check terminals 1 and 2 for 12 to 24 VAC or VDC.
  • Keep the field clear during setup with all lenses installed. A green 2 Hz flash means it saw something.
  • Mount it so stationary objects are not too close, and avoid high intensity lighting or change the frequency.

Door will not open after setup

  • The red LED is on: something in the field changed. Run setup again and retest the door.

Common questions

It can be set up to meet ANSI A156.10 for automatic pedestrian doors. Follow the user guide and the door manufacturer instructions, and run a daily safety check.

6 ft 6 in to 8 ft. The maximum is 9 ft.

Yes. It has a monitoring input and can be externally monitored by the door control.