Diablo DSP-10 Vehicle Detector Manuals & Support

Diablo DSP-10-LV / DSP-10-117

The Diablo Controls DSP-10 is a full featured single channel plug-in loop detector with two relay outputs and an 11-pin connector. It also works with the Diablo Free Exit Probe.

Output A can be fail-safe or fail-secure. Output B runs presence, pulse on entry, pulse on exit or loop fail. Sensitivity boost and extended presence handle trucks and parked vehicles.

Buy the DSP-10-LV / DSP-10-117 (2 options)

Identify your model

DSP-10-LV: 10 to 30 VDC or 10 to 28 VAC. DSP-10-117: 115 VAC version. Both are 2.36 x 1.75 x 4.09 in.

Key specs

Channels 1 loop, 2 relay outputs
Relays NO and NC, 3 A
Power (LV) 10 to 30 VDC or 10 to 28 VAC
Connector 11-pin
Sensitivity 10-position switch, 4 frequencies
Timing Delay and extension

Manuals and documents

Installation Manual

Quick Start

Spec Sheet

Other documents

Troubleshooting

Gate does not open or reopen

  • Check the detect LED when a vehicle is on the loop.
  • Raise the sensitivity one step at a time.

Detector stays in detect

  • Check the loop and lead-in for a break or short to ground.
  • Reset the detector so it retunes.

Random detects

  • Set nearby detectors to different frequencies.
  • Check that the lead-in is twisted and the saw cut is sealed.

Common questions

Yes. The DSP-10 supports the Diablo Free Exit Probe.

Use the DSP-10-LV on low voltage operators and the DSP-10-117 on 115 VAC.

Use direct-burial loop wire such as 16 AWG XLPE, not THHN. Twist the lead-in about 6 turns per foot and seal saw cuts with loop sealant.