Diablo DSP-19 Low Power Loop Detector Manuals & Support

Diablo DSP-19

The Diablo DSP-19 is a low power single channel plug-in loop detector for LiftMaster CSW24 operators and others that take the same detector.

It works with a loop or the Diablo Free Exit Probe. A DIP switch selects fail-safe or fail-secure.

Buy the DSP-19

Identify your model

DSP-19: rear Molex connector, 2.362 x 0.866 x 2.008 in.

Key specs

Power 8 to 35 VDC
Draw 1 mA max, no call
Output Open drain, 250 mA at 30 V
Loop range 20 to 1500 uH
Temperature -35 to 165 F

Manuals and documents

Installation Manual

Spec Sheet

Troubleshooting

Detector does not see vehicles

  • Check loop resistance and megger the loop to ground.
  • Check that the lead-in is twisted and the splice is sealed.

Random detects

  • Seal the slot so the wires cannot move.
  • Keep loops at least 3 ft from other loops and moving metal.

Common questions

LiftMaster CSW24 and others with the same plug-in port.

No. DC only.

No. Never use fail-secure or a probe on a safety loop.