Diablo DSP-7LP Low Power Vehicle Detector Manuals & Support

Diablo DSP-7LP

The Diablo Controls DSP-7LP is a low power single channel loop detector with one relay output and a 7-pin terminal block. It draws about 1 mA with no vehicle, for solar gates.

It has no switches. It tunes itself to the loop and is fail-safe, so it can be used on a safety loop.

Buy the DSP-7LP

Identify your model

The DSP-7LP is 1.52 x 2.9 x 1.56 in. Pins 1 to 3: relay NC, common, NO. Pins 4 and 5: power. Pins 6 and 7: loop.

Key specs

Power 10 to 30 VDC or 10 to 28 VAC
Current draw About 1 mA, no vehicle
Relay NO and NC, 1 A
Fail mode Fail-safe
Loop inductance 20 to 2,000 µH
Operating temperature -35 to 165 °F

Manuals and documents

Spec Sheet

Other documents

Troubleshooting

Gate does not open or reopen

  • Check the detect LED when a vehicle is on the loop.
  • Raise the sensitivity one step at a time.

Detector stays in detect

  • Check the loop and lead-in for a break or short to ground.
  • Reset the detector so it retunes.

Random detects

  • Set nearby detectors to different frequencies.
  • Check that the lead-in is twisted and the saw cut is sealed.

Common questions

A blink once a second is normal. A slow blink means an open loop and a fast blink a shorted loop.

The DSP-7LP is fail-safe for safety loops. The DSP-6LP is the fail-secure version for free exit loops.

No. It adjusts itself to the loop and lead-in.